Multitubular Dust Collector Type - K

INDVENT Multiclone Dust Controller Type-K meets the demand for high efficiency and is suitable for all purposes. The Dust Collector type-K is constituted in modular form to handle any volume of dusty air and ensures equal efficiency from the largest to the smallest unit.

Construction

The collector is build up of unit cells. Each cell consists of two concentric tubes, an outer cylinder with stationary vanes fixed at the inlet end, and an inner clean gas tube which passes upwards through the centre of the fixed vanes.

Principle

The dust particle bearing gas enters at the top of each cell through the fixed vanes which impart a swirl and throw the dust to the wall of the outer tube. The clean gas then reverses direction before leaving through the clean gas tube, while the dust discharges downwards into a hopper, common to a bank of cells.

Efficiency and Space Requirements

No. of
tubes
Volume
(m/hr.)
Dimensions in mm.
A
B
C
E
F
G
40 10,500 2880 3060 1100 700 1610 1440
48 13,000 3360 3200 1150 800 1660 1640
56 15,000 3840 3460 1250 950 1735 1880
64 17,000 4320 3660 1300 1100 1810 2120
72 19,500 5000 3660 1150 1250 1885 1640
84 23,000 5720 3960 1250 1450 1985 1880
96 29,500 6440 4210 1300 1650 2085 2120
Note: All dimensions are approximate & subject to change without notice.